With the use of Toolox 44® an additional heat treatment that is normally necessary can be saved, also the loss of time resulting from it as well as the expenses and the risk of waste.
a quicker machinability (about 20–25 %) than 1.2312 can be polished in an optimal way can be easily photo-etched (like 1.2311) practically without any residual stress thus an almost non-warping machining is possible hardness 300 HB strength ~ 950–1,125 N/mm² can be nitrided and coated with PVD
without residual stress thus almost distortion-free hardness 45 HRc, no heat treatment necessary can be nitrided and coated with PVD can be polished in an optimal way can be easily photo-etched
Toolox33®:
PräziPlan®Toolox33®
VarioPlan® Toolox33®
Mould Bases Toolox33®
Raw Material Toolox33®
Machining ServiceFurther information on the following cover sheets for download:
Specification Toolox33®Success stories / Example of use
Bending tool Toolox33®
Rack Toolox33®
Plastic mould Toolox33® and Toolox44®
Comparison of hardnessVarioPlan® made of Toolox® exclusively available at Recknagel!
VarioPlan® is a registered trademark of Recknagel Präzisionsstahl GmbH, Hückeswagen, Germany. Toolox® is a registered trademark of SSAB Oxelösund AB, Sweden.
Toolox44®
PräziPlan® in Toolox44®VarioPlan® in Toolox44®
VarioRond® in Toolox44®Raw Material in Toolox44®Machining ServiceFurther information on the following cover sheets for download:
Specification Toolox44®Success stories / Example of use
Flanges Toolox44®
Halteschlüssel Toolox 44
Plastic mould Toolox44®
Plastic mould II Toolox44®
Bar steel millToolox44®
Wear strip Toolox44®4Toolox - VarioPlan® made of Toolox® exclusively available at Recknagel!
VarioPlan® is a registered trademark of Recknagel Präzisionsstahl GmbH, Hückeswagen, Germany. Toolox® is a registered trademark of SSAB Oxelösund AB, Sweden.
